USBs these days are actually necessities which people need in order to store important data that they have. Of course with it being so popular, many people would actually think of jazzing these thumb drives up a bit. One can actually make custom made usb drives in his home without spending too much.

Now the first step in doing this would be to get a thumb drive and take out the existing case. It is important to get the internals because this is what will be used to make the custom made drive. One has to be very careful though because the internal part of the drive is quite sensitive.

A suggested thing to do would be to use a screwdriver instead of bare hands to split open the case. Now do take note that there are no screws on thumb drives but it will be help to snap open the covering. With a screwdriver, it will also be less likely that one will damage the internal part because he will not need to use too much force.

The next step in this process would be to find an outer covering for the thumb drive. Now this is the rather interesting part because this is where one can get creative. This outer covering can be made from practically any material ranging from plastic to metal or anything else.

Some things that most people would use would be plastic toys, some clay doh, or even lego bits. Of course one can actually get other things that he may use depending on his own artistic mood. Now once the outer covering has been gotten, the next part will be a little bit challenging.

Of course he must use the drill to drill a hole into the toy just in case there is no hole that can be found there. Now the important thing here to do would be to measure the length and the width of the thumb drive in order to know how big the hole should be. Upon making the hole, one just has to slot the drive inside.

The last step in the process is to use some epoxy or super glue to stick the thumb drive to the hole. To do this step, one has to just slot the drive inside the hole then put the glue all over the entrance of the hole. After that, he should let the glue dry by putting the newly made thumb drive across an electric fan so that the glue will dry.

So basically, those are some steps on how to create a custom thumb drive. Most people would go to stores in order to make these things. However, one can actually save a lot of money and time if he would just learn the easy steps of creating these things at his very home. These steps are extremely easy to do and practically anyone can do it as long as he has some basic materials at home.